Q: Should this be installed at the highest (indoor) part of pipe ? Q: Can you wire an appliance cord to it and just plug it in?Ī: Yes, provided it is a grounded cord and is kept from hot surfaces. ![]() Q: Can this unit be used out doors a nd can it get wetĪ: It is not rated to be in a wet environment.would need shelter. It also must be installed in single wall pipe, so if the system is double wall, the fan must be in a single wall section. Q: Can I mount this anywhere along the chimney pipe? Does it work with dual wall 6 pipe?Ī: It must be mounted in accordance with Tjernlund directions.2 feet from stove or combustible materials. Its inside.Ī: It cannot be used on double wall, a section would need to be rep[laced with single wall at point of installation. Q: hello, I am looking to tie into a double walled pipe, wondering if it can be done. You must maintain an 18 inches clearance from combustibles to the AD-1 housing. Q: Will this fit a single wall 6 stove pipe?Ī: The Auto-Draft requires a straight section of single wall stove pipe for installation. ![]() Per instructions: Once the fire is burning, adjust the variable speed control knob on the electrical box for maximum efficiency. Q: Does the fan have to be on all the while the stove is burning or can you turn it off after lighting?Thanks,Ī: Ideally yes. Q: Can I use this as a booster fan for a gas hot water heater exhaust chimney?Ī: No, this unit is for wood burning stoves only. ![]() Installation on horizontal vent pipes must be made on the underside of the pipe to prevent excessive heat build up within the fan housing. Q: Can this be used horizontally? I do not have much vertical pipe due to warming oven.Ī: Per the installation manual: The Auto-Draft may be mounted on horizontal, vertical or inclined vent The fan motor is permanently sealed and requires no oiling. Soot and creosote build up must be removed from both the fan wheel and housing. Q: I am assuming since creosote can build up in the flue.can it also build up in the fan housing and on the blades? How often, and how do you clean it out?Ī: Per the installation manual: Depending upon the type of wood burned, the fan must be removed from the vent pipe and cleaned at least once per year. Do you have questions about the products on this page?Ĭlick on the ? image on the left or this link to ask us your questions!
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |